3 steps to conduct your commercial roof inspection

A service agreement with the roof installer is your best choice for routine maintenance procedures. However, internal employees that are qualified and taking safety precautions may also conduct inspections and perform minor maintenance. After an initial roof survey, it’s advisable to plan regular inspections twice a year. By the time a roof leak is apparent, the problem may already be acute, and repair is likely to be costly. The spring and the fall are the best times for this check-up. In the spring, check for potential damage that could have occurred from severe winter storms and determine necessary repairs. In the fall, check for any preventive action required before winter.

A best practice is to review the elements of your roof methodically, so you don’t miss anything. Chubb Risk Engineering Services roofing specialists recommend doing inspections in the following order:
 

• Building interior. Lift ceiling tiles and the underside of the deck for signs of water and note any water marks on ceilings, surfaces, and walls, which may be caused by roof leaks.
• Building exterior. Check for signs of misalignment due to settlement of the foundation and walls and for unadhered shingles. Inspect drains and downspouts to make sure they’re clear of obstructions and aren’t damaged. Look for evidence of standing water.
• Roof membrane. Note if the membrane is properly adhered to perimeters and flashings and check the fastenings. Document tears or punctures in the membrane. 
• Roof flashings. Many roof leaks originate with flashing. Inspect each flashing and make sure they are properly attached.
• Exterior installed equipment. Careless workers or improper installation of roof-mounted equipment — such as satellite dishes, skylights, AC units, or ventilation fans — can cause damage. Make sure any new apparatus has proper, intact flashing.

Remember to keep a list of problem areas, flag susceptibilities to monitor, and address issues that require immediate attention.